Hello! I'm tracking down an issue with my Athom WLED Sounds Reactive Addressable Strip controller.
The issue is that when I turn the LED on or off with Home Assistant via the built-in WLED integration, the LED doesn't actually change. I ran tcpdump and confirmed the command is being sent, and if I have WLED open the Power toggle will change - but the light doesn't! After a minute or so it will start responding again.
The issue happens both in the 0.14.4 firmware shipped by Athom, and in WLED 0.15.0. I'm connected to ~2m of a BTF LED strip, connected to a 70W power supply with the barrel plug. It's only peaked at 25W use so I think the power supply is good (and it's not like WLED is rebooting).
Any ideas?
Actually, here's the JSON version from a config backup which may be easier to read. Thanks!
"hw": {"led": {"total": 152,"maxpwr": 9000,"ledma": 0,"cct": true,"cr": false,"ic": false,"cb": 0,"fps": 42,"rgbwm": 255,"ld": true,"ins": [{"start": 0,"len": 152,"pin": [18],"order": 0,"rev": false,"skip": 0,"type": 22,"ref": false,"rgbwm": 0,"freq": 0,"maxpwr": 9000,"ledma": 55}]},"com": [],"btn": {"max": 4,"pull": true,"ins": [{"type": 2,"pin": [0],"macros": [0,0,0]},{"type": 0,"pin": [-1],"macros": [0,0,0]},{"type": 0,"pin": [-1],"macros": [0,0,0]},{"type": 0,"pin": [-1],"macros": [0,0,0]}],"tt": 32,"mqtt": false},Here's the GPIO settings. I haven't changed any of them from the defaults:
I did notice something else since I posted. Occasionally when turning off, the LED would only dim (to around 20% of full brightness) instead of turning off. So, I turned off transitions. Since, I haven't noticed any issues, but it's only been less than a day. It does have me suspecting there's some sort of bug in the transition code in WLED.
Please send your GPIO configuration for the LED interface