Hello Community,
I recently purchased a WLED ESP32 RF433 Music Addressable LED Strip Controller set that comes with an IR Remote, RF433 Switch, and RF433 PIR Sensor. I'm pleased with the controller and IR remote; they are working perfectly. The built-in microphone is also excellent.
However, I'm facing challenges with the RF433 Switch and RF433 PIR Sensor. Both of them light up blue when triggered (Switch when pressed and PIR Sensor when it detects motion), but they don't seem to affect the LED controller.
In the WLED settings, both options (RF433 Switch and RF433 PIR) are activated by default.
Can anyone guide me through the steps needed to make these components communicate successfully with the main controller? Is there any pairing or specific configurations that I need to consider?
Thank you in advance for your assistance.
Best regards, Daniel
Yes, you need to pair the sensor with the controller and modify the default parameters, please refer to the manual