כדי לראות את זה בפעילות, יש לעבור לאתר הפעיל שלך.

Troubleshooting Issue with RF433 Switch and PIR Sensor on WLED ESP32 Controller

Hello Community,

I recently purchased a WLED ESP32 RF433 Music Addressable LED Strip Controller set that comes with an IR Remote, RF433 Switch, and RF433 PIR Sensor. I'm pleased with the controller and IR remote; they are working perfectly. The built-in microphone is also excellent.

However, I'm facing challenges with the RF433 Switch and RF433 PIR Sensor. Both of them light up blue when triggered (Switch when pressed and PIR Sensor when it detects motion), but they don't seem to affect the LED controller.

In the WLED settings, both options (RF433 Switch and RF433 PIR) are activated by default.

Can anyone guide me through the steps needed to make these components communicate successfully with the main controller? Is there any pairing or specific configurations that I need to consider?

Thank you in advance for your assistance.

Best regards, Daniel

7 תגובות

לייק

Comments (7)

Gary Cruz

02 בנוב׳ 2023

I also received this same setup but cant get the PIR or the rf433mhz controller to work. Too bad they don't sync them before they mail them out as I can't find how to configure them.

לייק

Athom_Support

01 בנוב׳ 2023

Yes, you need to pair the sensor with the controller and modify the default parameters, please refer to the manual

לייק

Gary Cruz

02 בנוב׳ 2023

בתשובה לפוסט של

For RF switch and PIR sensor to work.

1. Go to the Info Page

2. Press the RF switch. The RF433 receive will show a number. Copy that number in the config -> user mods page in RF433Switch > switchdata (replace the number)

3. Go Back to the Info screen

4. Now move the PIR sensor, the RF433 Receive will change number

5. Copy that number

6. Go to the Usermode Setup and copy that number under RF433Pir > pirdata: (there should be a 0 there, just replace it)

7. Click the RF Switch, it will power on and off.

8. When Off, move the PIR sensor and it will turn on!

The little manual has this info, but it was easy to miss.

לייק

Gary Cruz

02 בנוב׳ 2023

בתשובה לפוסט של

For RF switch and PIR sensor to work.

1. Go to the Info Page

2. Press the RF switch. The RF433 receive will show a number. Copy that number in the config -> user mods page in RF433Switch > switchdata (replace the number)

3. Go Back to the Info screen

4. Now move the PIR sensor, the RF433 Receive will change number

5. Copy that number

6. Go to the Usermode Setup and copy that number under RF433Pir > pirdata: (there should be a 0 there, just replace it)

7. Click the RF Switch, it will power on and off.

8. When Off, move the PIR sensor and it will turn on!

The little manual has this info, but it was easy to miss.

לייק

Daniel Götzinger

04 בנוב׳ 2023

בתשובה לפוסט של

thx for your note

it work like charm, when you know it

לייק

Troubleshooting Issue with RF433 Switch and PIR Sensor on WLED ESP32 Controller

Terms of Use

Privacy Policy

Shipping Policy

Return Policy