I just recived my WLED High Power Addressable LED Strip Controller and I was wondering if its possible to connect it to a wall switch button to turn it on/off, if so, where I can find the wiring diagram? Tried to google it but I found nothing.
top of page
bottom of page
IR OUT has 3 Pins? 2 should be GPIO25 and GND (+VCC?)...
you need to test and change the Button in wled from GPIO 0 to 25..
i try to get 2 stripes to the original button but no way :( it has 4 pins and not just 2.. over the IR out/gpio should be the easiest way... over LED2-DATA + GND it works too BUT i dont know here because of the buildin level-shifter...
and there ara no more gpios on athom.. why? the esp32 has much more...
best way for buttons: gpio 0 + gnd..
This needs to be wired separately, and the shell needs to be opened. If you need to be beautiful, you can consider buying the esp32 version, and then set the infrared remote control interface as a switch