top of page
כדי לראות את זה בפעילות, יש לעבור לאתר הפעיל שלך.
Can the LS5P be used to control a 24 Volt Tunable Single color LED? If so, what where should the three wires go? What power supply needed?
Can the LS5P be used to control a 24 Volt Tunable Single color LED? If so, what where should the three wires go? What power supply needed?
9 תגובות
לייק
Comments (9)
bottom of page
I was advised to connect as follows:
VCC----->Red
R---------->Yellow
G---------->White
Following these instructions causes the controller to lock in the on position and not accept commands.
I experimented with several combinations and the correct wiring for a tunable white COB strip is:
VCC----->Red
R---------->White
W---------->Yellow