I have these analog RGB lights that are hooked up to the new WLED RGBW Light Strip Controller and I can't seem to get the lights to come on. I have a voltmeter reading 12V at the light itself, but the lights are not on. I have tried everything on the WLED settings and I am lost on which direction to go. I can directly apply the + / - lines to the light from the dc power and I can get the lights to flicker, so I know I have the correct voltage. What could be going on?
top of page
![](https://static.wixstatic.com/media/11062b_ea61c0ecc8b34ecd942c42470507e640f000.jpg/v1/fill/w_288,h_162,al_c,q_80,usm_0.66_1.00_0.01,blur_2,enc_auto/11062b_ea61c0ecc8b34ecd942c42470507e640f000.jpg)
כדי לראות את זה בפעילות, יש לעבור לאתר הפעיל שלך.
Comments (4)
bottom of page
Try this firmware, pay attention to the GPIO settings
https://drive.google.com/file/d/1Zsu1quUVOV58tnyU2_cNf8JiSBHHVBXs/view?usp=share_link