Are there any "easily accessible" solder pads on the plug PCB to reprogram the ESP32-C3 module on these units.
If not, is there a way to non-destructively remove the bottom plastic plate so I can access the contacts of the module from underneath the PCB?
Thanks.
The SRD grant, though a short-term intervention, provides a critical safety net for many people in South Africa. For individuals who are struggling financially due to job loss, illness, or other unforeseen circumstances, the grant serves as an essential lifeline. As the country continues to face challenges related to economic instability Sassa status check, inequality, and unemployment, the SRD grant remains one of the most important tools for providing immediate relief to those in need.
Need to connect GP9 to GND to enter flash mode
https://tasmota.github.io/docs/Pinouts/#jw-2s-esp32c3