Hi everyone,
i just received a couple of devices from Athom. I managed to install the LED Bulbs and the switches/plugs - altough I bricked one LED when trying to use official tasmota.bin.gz release (followed the description in this board).
Now, with the relays it is entirely different. There is a totally different firmware installed and while I manage to configure the WLAN, I never get access to the web ui. The router shows an IP/DHCP lease, but the device start blinking now and then (did not figure the pattern yet). I could not access any web ui and thus the device appears unusable ... any hints?
I did a nmap scan that showed only one open port:
PORT STATE SERVICE REASON VERSION
5556/tcp open freeciv? syn-ack ttl 255
1 service unrecognized despite returning data. If you know the service/version, please submit the following fingerprint
I bought this device, so that i can use and customize it with tasmota firmware ... that said, is there a good way of opening the plastic cover to get to the esp chip?
Best,
Hannes
PS: the network it is connected to does not have internet access
Students seeking help with their assignments need to find dependable services based in the UK. Accessing expert help for your care plan essay mental health assignment will provide you with well-structured content and appropriate research together with timely submission so you can easily earn higher grades.
I am a medical student and have good hands when it comes to practice but sometimes, writing a complex assignment becomes pretty hard. I had to submit a report related to human anatomy but couldn't grasp it. I asked for help
from StudentHelpers, and they nailed it!
I got an assignment related to the subject of sociology. I find this subject to be quite dull. It was challenging to write an assignment on this subject, So, I did some online research and found Scholarsband. Choosing them to write my assignment from scratch was the best decision.
I got the tasmota version and they worked fine out the box as with other Athom tasmota based devices.
@johannes.ellinger Please check if you have bought the HomeKit version or the Tasmota based version of the switches. I had the same issue and Athom has identified that I had bought the HomeKit versions. By the way: they cannot be converted/flashed to Tasmota versions...
Same here...only connecting to homekit, but I want to use the relay switches with Home-Assistant....@support: any idea how we can get access to the WebUI?