Hi All,
I purchased 2 of these some time back and just getting around to configuring them. One configured without any issues, but the other will not accept the WiFi credentials.
So, the AP is shown and I connect to it. I then get the Configuration page to enter the WiFi SSID and password. I enter them (same as the other one that worked), click on SAVE and I get a green box stating the device will connect to the network and it could take some time. It never connects, the plugs AP is always up as my device never drops connection. I have tried this for hours with different devices (phone, a few laptops, etc) connting to the AP, but always exhibits the same outcome as mentioned above. The Blue LED is always flashing at a consitent rate.
I have tried to reset the plug (power on/off 4 times) to se to factory, but this hasnt changed any of the outcome. I noticed on the Config page I could upload a new BIN file. I tried to upload the standard config Athom have for this device, it seemed to start, went offline for a reboot and still exhibits the same outcome as above. Any ideas... Thanks, Rob