• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    כדי לראות את זה בפעילות, יש לעבור לאתר הפעיל שלך.
    • קטגוריות
    • כל הפוסטים
    • הפוסטים שלי
    Ayoze Aguiar
    20 בינו׳ 2021

    Is it possible to flash to tasmota from homekit, without open case, via web interface?

    ב- Plugs
    2 תשובותמשוב אחד
    0
    3 תגובות

    שיתוף המחשבות שלךצריך להירשם כדי להשאיר תגובה.

    N
    Neil Heuer
    Neil Heuer
    31 ביולי 2021

    It can be done. When the switch is in AP mode you have to go to 192.168.4.1/update then you can upload your own bin file. On my 4 gang it just started clicking so you have to do the device recovery after that.


    Procedure~

    1. Cut power from the device completely for 30 seconds

    2. Power the device on and off six times with intervals lower than 10 seconds and leave it on after seventh time

    3. Fast power cycle device recovery should activate and the device should be reset to firmware defaults

    1

    Athom_Support
    02 ביוני 2021

    Does not support upgrading from homekit to Tasmota

    1
    N
    Neil Heuer
    Neil Heuer
    31 ביולי 2021
    עונה ל-

    I did it on one of my switches but I don't remember HOW I did it and now I am stuck trying to do the other!

    לייק
    3 תגובות
    פוסטים דומים
    • Flash Homekit version switch with Tasmota?
    • Is it possible to flash plugs from Tuya to tasmota over the air by raspberry with hotspot?
    • How to add tasmota wifi relay to homekit via homebridge?

    ©2020 by athom.