top of page

Notice:

The orders shipped after 7th Aug 2024 are upgraded from ESP8266 to ESP32

 

This is open sources device, fully compatible with Homekit but not certified by Apple

The device support both Homekit and MQTT 

 

RF433 receiver built in

Built-in serial port chip, can directly carry out secondary development and flash firmware

 

WiFi Settings

Power on the device, then use your phone or computer search the WiFi, until find the name: Homekit-xxxxx, then connect. Wait several seconds until web pop up.

You can set user name and password for your device and choose DHCP or Static IP

 

Attention

If you want change default settings of other parameters, Please go set and save others parameters first then set and save WiFi setting.

If you set and save WiFi before setting other parameters, then the device will connect you router directly and the connection will lost. then you need to open your router find the IP address of the devices then use IP address to visit the device

 

Advanced Control Setttings

In this page, you can set :

Power On State
Switch Mode (Self-locking/Interlock/Inching etc)
Inching duration
Switch type etc.

 

Complete Settings

After setting features, Save it. The device will automatically connect your router.

Then open your Home App add new device until success. ( The code is : 12345678 )

Or go to you MQTT broker complete the settings.

 

DC 5V/DC 8-80V input 10A relay

 

Operating voltage: 5V/7-30V DC
relay on/off status respectively
Two input interfaces
Supports to control different voltage ranges
USB port power supply more convenient
Board consumption: <1W
Standby current: 80mA
Max input current: 10A
Max Wattage: 2200W
Relay lifespan: ≥one million times
100M electrical insulation resistance
Electric shock voltage: 1000V
Relay maximum pull time: 15ms
Relay maximum release time: 5ms
Working mode: inching / self-locking
Wireless Standard: 2.4GHz, 802.11 b/g/n
Application: access control, turn on PC, garage door, etc.
Computer application: Remote control computer boot
Operating temperature: -40 degrees to +70 degrees
Operating Humidity 40%-80% RH

 

Restart

To restart the board just press the button on the board

 

Reset

To reset the board,  you can go Control page to reset or Please use jump wire connect GND to TX for more than 6s and disconnect it. The board will be reset and you need to reinstall it again.

Homekit MQTT 2CH RF433 Inching/Self-lock/Interlock Relay

24.60$ מחיר רגיל
17.22$מחיר מבצע
    bottom of page